![](../../../images/5px.gif) |
![](images/intakepipe_gtr_ttl.jpg) |
![](../../../images/5px.gif) |
・ |
The genuine Mitsubishi intake pipes are mainly constructed of rubber hoses. Deformation is prevented by exchanging to aluminium pipes, also increasing throttle response. |
・ |
Durability and engine safety are greatly increased at the same time. |
・ |
With the pipework finished in buff aluminum, and blue silicone replacement hoses used, the engine bay appearance is greatly enhanced. |
・ |
Individual vehicle settings available with an easy bolt on installation. |
|
![](../../../images/5px.gif) |
Line Up |
GT-R |
07/12- |
R35 |
VR38DETT |
SpecV not confirmed |
\115,500 |
\110,000 |
12902 |
LANCER EVOLUTION X |
07/10- |
CZ4A |
4B11 |
Common with MT/SST
|
\60,900 |
\58,000 |
12901 |
|
![](../../../images/5px.gif) |
|
・ |
The genuine Nissan intake pipes are mainly constructed of rubber hoses. Deformation is prevented by exchanging to aluminium pipes, also increasing suction rate and throttle response. The set incorporates the turbine Intake pipe to enter I/C, I/C exit to Throttle. (8 piece set) |
・ |
Corresponds with the genuine cleaner box and recirculation bulb. Can be used with BLITZ SUPER SOUND BLOWOFF VALVE VD |
・ |
With the pipework finished in buff aluminum, and blue silicone replacement hoses used, the engine bay appearance is greatly enhanced. |
・ |
IIndividual vehicle settings available with an easy bolt on installation. ※Suction kit for R35 now available! |
|
|
The genuine Nissan intake pipes are mainly constructed of rubber hoses.
Deformation is prevented by exchanging to aluminium pipes, also increasing suction rate andthrottle response. |
![](images/intake_r35_pipe.jpg) |
|
Outer I/C→Throttle pipe installation image |
![](images/intakepipe_souchaku.jpg) |
※This product can be installed with Genuine air cleaner box.
※Vehicle pictured are installed with other than INTAKE PIPE KIT. |
|
![](../../../images/5px.gif) |
Aluminum Pipe No.1 |
|
Before exchange |
After exchange |
Aluminum casting Turbo outlet pipingExchange from plastic to Aluminum casting.Increase outer diameter from φ45(Genuine)to φ60. |
![](images/no1_j.jpg) |
![](images/no1_b.jpg) |
![](images/no1.jpg)
|
|
|
|
Aluminum Pipe No.2 |
|
Before exchange |
After exchange |
φ60 Aluminum bend pipe.Exchange from genuine rubber hose to Aluminum pipe.Using equivalent diameter for Genuineφ60 |
![](images/no2_j.jpg) |
![](images/no2_b.jpg) |
![](images/no2.jpg) |
|
|
※Radiator hose is not Genuine in this picture |
|
|
|
Aluminum pipe No.3 + silicone hose |
|
Before exchange |
After exchange |
φ70 Aluminum bend pipe and φ70 silicone hose.
Exchange from genuine rubber hose to Aluminum, and silicone hose. |
![](images/no3_j.jpg) |
![](images/no3_b.jpg) |
![](images/no3.jpg) |
![](images/no3_j2.jpg) |
![](images/no3_b2.jpg) |
|
|
|